QuickChange Toolpost

QUICK CHANGE TOOLPOST TO FIT MYFORD

A Superb quick change toolpost to fit myford ML7 and SUPER 7 lathes,All parts are hardened and ground, set of five pieces- the toolpost Block,2 standard holders.1 parting holder and 1 vee holder for boring also comes complete with 2 allan headed spanners for adjustment of the post

Main block 2 1/4 " square, 1 1/2" high with a 7/16" bore.

BOXFORD TI QUICK CHANGE TOOLPOST SET (51mm)

Quality quick change toolpost for boxford laths,fits aud.bud,and cud models,all parts hardened and ground, set complete with 2 standard holders,one boring holder and 1 parting holder.

Main Block 3" square x 2" high with a 5/8 Bore

( this set is larger than the myford set )

T1 QUICKCHANGE TOOLPOST (SPECIAL OFFER) (63mm)

Quality quick change toolpost for HARRISON AND COLCHESTER chipmasters/ bantams or any 5-1/2" - 6" lathe's,

fitsCOLCHESTER CHIPMASTER, HARRISON ECT WITH CORRECT CENTER HIGHT,all parts hardened and ground,

set complete with 2 standard holders,one boring holder and 1 parting holder.

Main Block 72mm square x 63MM high with a 16.5mm Bore

T2 QUICKCHANGE BLOCK SET ( COLCHESTER STUDENT/MASTER )

A FULL NEW QUICKCHANGE SET FOR A COLCHESTER STUDENT / MASTER LATHE OFTEN KNOWN AS A T2 SET

THIS UNIT IS INTERCHANGEABLE WITH THE DIXON QUICKCHANGE

THE DIMENSIONS FOR THIS BLOCK ARE:

BLOCK: 72MM HIGH, 97MM SQUARE, BORE IS 25.4MM / 1" COMES WITH A REDUCING SLEEVE WHICH IS 16.8MM

THIS SET COMES COMPLETE WITH BLOCK, 2 STANDARD HOLDER'S, ADJUSTING KEY AND REDUCING SLEEVE

THIS BLOCK IS DESIGNED FOR MACHINES WITH A CENTRE HEIGHT OF BETWEEN 6 AND 7" OR THERE ABOUT'S

THIS IS A QUALITY UNIT,

CLICK HERE FOR A LARGER PICTURE..........>

SPARE HOLDERS FOR QUICK CHANGE ( MYFORD SIZE )

SPARE HOLDER FOR QUICK CHANGE (3.1/2")

MYFORD SIZE

SPARE HOLDERS FOR QUICK CHANGE (T1) "16mm capacity"

SPARE HOLDER FOR QUICK CHANGE

WILL TAKE A 16MM TOOL

KNOWN AS A T1 TOOLHOLDER

USED ON MACHINES LIKE BOXFORDS AND SMALL HARRISONS

TAKE UPTO 16MM TOOLS

SPARE HOLDERS FOR QUICK CHANGE (T1) "20mm capacity"

SPARE HOLDER FOR QUICK CHANGE

WILL TAKE A 20MM TOOL

KNOWN AS A T1 TOOLHOLDER

USED ON MACHINES LIKE HARRISON M300 / CHIPMASTER BANTAM ETC

SPARE HOLDERS FOR QUICK CHANGE (T2) studant / master

SPARE HOLDER FOR QUICK CHANGE

KNOWN AS A T2 TOOLHOLDER

USED ON MACHINES LIKE COLCHESTER STUDENT / MASTER ETC

SIZE 98.5MM X 40MM X 50MM HIGH

TAKE UPTO 22MM TOOLS

(Block Size 98mm x 40mm x 50mm high)

TOOLPOST SPANNER 5/16" / 8MM SQUARE

LATHE TOOLPOST SPANNER

5/16" / 8mm square

used on interchangeable toolpost's